kernel/linux.git/drivers/pinctrl/bcm, branch v4.14.263

pinctrl: iproc-gpio: Fix incorrect pinconf configurations

2020-01-27T13:46:47+00:00

[ Upstream commit 398a1f50e3c731586182fd52b834103b0aa2f826 ] Fix drive strength for AON/CRMU controller; fix pull-up/down setting for CCM/CDRU controller. Fixes: 616043d58a89 ("pinctrl: Rename gpio driver from cygnus to iproc") Signed-off-by: Li Jin Link: https://lore.kernel.org/r/1567054348-19685-2-git-send-email-srinath.mannam@broadcom.com Signed-off-by: Linus Walleij Signed-off-by: Sasha Levin

pinctrl: ns2: Fix off by one bugs in ns2_pinmux_enable()

2019-11-10T10:25:07+00:00

[ Upstream commit 39b65fbb813089e366b376bd8acc300b6fd646dc ] The pinctrl->functions[] array has pinctrl->num_functions elements and the pinctrl->groups[] array is the same way. These are set in ns2_pinmux_probe(). So the > comparisons should be >= so that we don't read one element beyond the end of the array. Fixes: b5aa1006e4a9 ("pinctrl: ns2: add pinmux driver support for Broadcom NS2 SoC") Signed-off-by: Dan Carpenter Link: https://lore.kernel.org/r/20190926081426.GB2332@mwanda Acked-by: Scott Branden Signed-off-by: Linus Walleij Signed-off-by: Sasha Levin

pinctrl: bcm2835: Use raw spinlock for RT compatibility

2019-02-12T18:45:56+00:00

[ Upstream commit 3c7b30f704b6f5e53eed6bf89cf2c8d1b38b02c0 ] The BCM2835 pinctrl driver acquires a spinlock in its ->irq_enable, ->irq_disable and ->irq_set_type callbacks. Spinlocks become sleeping locks with CONFIG_PREEMPT_RT_FULL=y, therefore invocation of one of the callbacks in atomic context may cause a hard lockup if at least two GPIO pins in the same bank are used as interrupts. The issue doesn't occur with just a single interrupt pin per bank because the lock is never contended. I'm experiencing such lockups with GPIO 8 and 28 used as level-triggered interrupts, i.e. with ->irq_disable being invoked on reception of every IRQ. The critical section protected by the spinlock is very small (one bitop and one RMW of an MMIO register), hence converting to a raw spinlock seems a better trade-off than converting the driver to threaded IRQ handling (which would increase latency to handle an interrupt). Cc: Mathias Duckeck Signed-off-by: Lukas Wunner Acked-by: Julia Cartwright Signed-off-by: Linus Walleij Signed-off-by: Sasha Levin

pinctrl: nsp: Fix potential NULL dereference

2018-08-24T11:09:17+00:00

[ Upstream commit c29e9da56bebb4c2c794e871b0dc0298bbf08142 ] platform_get_resource() may fail and return NULL, so we should better check it's return value to avoid a NULL pointer dereference a bit later in the code. This is detected by Coccinelle semantic patch. @@ expression pdev, res, n, t, e, e1, e2; @@ res = platform_get_resource(pdev, t, n); + if (!res) + return -EINVAL; ... when != res == NULL e = devm_ioremap_nocache(e1, res->start, e2); Fixes: cc4fa83f66e9 ("pinctrl: nsp: add pinmux driver support for Broadcom NSP SoC") Signed-off-by: Wei Yongjun Reviewed-by: Ray Jui Signed-off-by: Linus Walleij Signed-off-by: Sasha Levin Signed-off-by: Greg Kroah-Hartman

pinctrl: nsp: off by ones in nsp_pinmux_enable()

2018-08-24T11:09:17+00:00

[ Upstream commit f90a21c898db58eaea14b8ad7e9af3b9e15e5f8a ] The > comparisons should be >= or else we read beyond the end of the pinctrl->functions[] array. Fixes: cc4fa83f66e9 ("pinctrl: nsp: add pinmux driver support for Broadcom NSP SoC") Signed-off-by: Dan Carpenter Reviewed-by: Ray Jui Signed-off-by: Linus Walleij Signed-off-by: Sasha Levin Signed-off-by: Greg Kroah-Hartman

License cleanup: add SPDX GPL-2.0 license identifier to files with no license

2017-11-02T10:10:55+00:00

Many source files in the tree are missing licensing information, which makes it harder for compliance tools to determine the correct license. By default all files without license information are under the default license of the kernel, which is GPL version 2. Update the files which contain no license information with the 'GPL-2.0' SPDX license identifier. The SPDX identifier is a legally binding shorthand, which can be used instead of the full boiler plate text. This patch is based on work done by Thomas Gleixner and Kate Stewart and Philippe Ombredanne. How this work was done: Patches were generated and checked against linux-4.14-rc6 for a subset of the use cases: - file had no licensing information it it. - file was a */uapi/* one with no licensing information in it, - file was a */uapi/* one with existing licensing information, Further patches will be generated in subsequent months to fix up cases where non-standard license headers were used, and references to license had to be inferred by heuristics based on keywords. The analysis to determine which SPDX License Identifier to be applied to a file was done in a spreadsheet of side by side results from of the output of two independent scanners (ScanCode & Windriver) producing SPDX tag:value files created by Philippe Ombredanne. Philippe prepared the base worksheet, and did an initial spot review of a few 1000 files. The 4.13 kernel was the starting point of the analysis with 60,537 files assessed. Kate Stewart did a file by file comparison of the scanner results in the spreadsheet to determine which SPDX license identifier(s) to be applied to the file. She confirmed any determination that was not immediately clear with lawyers working with the Linux Foundation. Criteria used to select files for SPDX license identifier tagging was: - Files considered eligible had to be source code files. - Make and config files were included as candidates if they contained >5 lines of source - File already had some variant of a license header in it (even if <5 lines). All documentation files were explicitly excluded. The following heuristics were used to determine which SPDX license identifiers to apply. - when both scanners couldn't find any license traces, file was considered to have no license information in it, and the top level COPYING file license applied. For non */uapi/* files that summary was: SPDX license identifier # files ---------------------------------------------------|------- GPL-2.0 11139 and resulted in the first patch in this series. If that file was a */uapi/* path one, it was "GPL-2.0 WITH Linux-syscall-note" otherwise it was "GPL-2.0". Results of that was: SPDX license identifier # files ---------------------------------------------------|------- GPL-2.0 WITH Linux-syscall-note 930 and resulted in the second patch in this series. - if a file had some form of licensing information in it, and was one of the */uapi/* ones, it was denoted with the Linux-syscall-note if any GPL family license was found in the file or had no licensing in it (per prior point). Results summary: SPDX license identifier # files ---------------------------------------------------|------ GPL-2.0 WITH Linux-syscall-note 270 GPL-2.0+ WITH Linux-syscall-note 169 ((GPL-2.0 WITH Linux-syscall-note) OR BSD-2-Clause) 21 ((GPL-2.0 WITH Linux-syscall-note) OR BSD-3-Clause) 17 LGPL-2.1+ WITH Linux-syscall-note 15 GPL-1.0+ WITH Linux-syscall-note 14 ((GPL-2.0+ WITH Linux-syscall-note) OR BSD-3-Clause) 5 LGPL-2.0+ WITH Linux-syscall-note 4 LGPL-2.1 WITH Linux-syscall-note 3 ((GPL-2.0 WITH Linux-syscall-note) OR MIT) 3 ((GPL-2.0 WITH Linux-syscall-note) AND MIT) 1 and that resulted in the third patch in this series. - when the two scanners agreed on the detected license(s), that became the concluded license(s). - when there was disagreement between the two scanners (one detected a license but the other didn't, or they both detected different licenses) a manual inspection of the file occurred. - In most cases a manual inspection of the information in the file resulted in a clear resolution of the license that should apply (and which scanner probably needed to revisit its heuristics). - When it was not immediately clear, the license identifier was confirmed with lawyers working with the Linux Foundation. - If there was any question as to the appropriate license identifier, the file was flagged for further research and to be revisited later in time. In total, over 70 hours of logged manual review was done on the spreadsheet to determine the SPDX license identifiers to apply to the source files by Kate, Philippe, Thomas and, in some cases, confirmation by lawyers working with the Linux Foundation. Kate also obtained a third independent scan of the 4.13 code base from FOSSology, and compared selected files where the other two scanners disagreed against that SPDX file, to see if there was new insights. The Windriver scanner is based on an older version of FOSSology in part, so they are related. Thomas did random spot checks in about 500 files from the spreadsheets for the uapi headers and agreed with SPDX license identifier in the files he inspected. For the non-uapi files Thomas did random spot checks in about 15000 files. In initial set of patches against 4.14-rc6, 3 files were found to have copy/paste license identifier errors, and have been fixed to reflect the correct identifier. Additionally Philippe spent 10 hours this week doing a detailed manual inspection and review of the 12,461 patched files from the initial patch version early this week with: - a full scancode scan run, collecting the matched texts, detected license ids and scores - reviewing anything where there was a license detected (about 500+ files) to ensure that the applied SPDX license was correct - reviewing anything where there was no detection but the patch license was not GPL-2.0 WITH Linux-syscall-note to ensure that the applied SPDX license was correct This produced a worksheet with 20 files needing minor correction. This worksheet was then exported into 3 different .csv files for the different types of files to be modified. These .csv files were then reviewed by Greg. Thomas wrote a script to parse the csv files and add the proper SPDX tag to the file, in the format that the file expected. This script was further refined by Greg based on the output to detect more types of files automatically and to distinguish between header and source .c files (which need different comment types.) Finally Greg ran the script using the .csv files to generate the patches. Reviewed-by: Kate Stewart Reviewed-by: Philippe Ombredanne Reviewed-by: Thomas Gleixner Signed-off-by: Greg Kroah-Hartman

pinctrl: bcm2835: fix build warning in bcm2835_gpio_irq_handle_bank

2017-09-21T12:11:10+00:00

This patch fix the following build warning: drivers/pinctrl/bcm/pinctrl-bcm2835.c:376:15: warning: variable 'type' set but not used [-Wunused-but-set-variable] Furthermore, it is unused for a long time, at least since commit 85ae9e512f43 ("pinctrl: bcm2835: switch to GPIOLIB_IRQCHIP") where a "FIXME no clue why the code looks up the type here" was added. A year after, nobody answeered this question, so its time to remove it. Signed-off-by: Corentin Labbe Acked-by: Stefan Wahren Signed-off-by: Linus Walleij

pinctrl: bcm281xx: constify pinconf_ops, pinctrl_ops, and pinmux_ops structures

2017-08-22T12:36:25+00:00

This pinconf_ops structure is only stored in the const confops field of a pinctrl_desc structure. Make the pinconf_ops structure const as well. Done with the help of Coccinelle. Signed-off-by: Julia Lawall Signed-off-by: Linus Walleij

pinctrl: bcm2835: Remove unneeded irq_group field

2017-08-14T13:01:02+00:00

The irq_group field stores a 1:1 mapping. Use the loop variable to derive the values instead of storing them in an extra array. Signed-off-by: Thierry Reding Signed-off-by: Linus Walleij

pinctrl: Convert to using %pOF instead of full_name

2017-08-14T13:01:02+00:00

Now that we have a custom printf format specifier, convert users of full_name to use %pOF instead. This is preparation to remove storing of the full path string for each node. Signed-off-by: Rob Herring Cc: Linus Walleij Cc: Lee Jones Cc: Stefan Wahren Cc: Florian Fainelli Cc: Ray Jui Cc: Scott Branden Cc: bcm-kernel-feedback-list@broadcom.com Cc: Tomasz Figa Cc: Sylwester Nawrocki Cc: Laurent Pinchart Cc: Barry Song Cc: linux-gpio@vger.kernel.org Cc: linux-rpi-kernel@lists.infradead.org Cc: linux-arm-kernel@lists.infradead.org Cc: kernel@stlinux.com Cc: linux-samsung-soc@vger.kernel.org Cc: linux-renesas-soc@vger.kernel.org Acked-by: Krzysztof Kozlowski Acked-by: Ludovic Desroches Acked-by: Patrice Chotard Reviewed-by: Geert Uytterhoeven Acked-by: Geert Uytterhoeven Acked-by: Eric Anholt Signed-off-by: Linus Walleij