kernel/linux.git/drivers/net/ipvlan/ipvlan.h, branch v6.12.80

ipvlan: Make the addrs_lock be per port

2026-01-30T09:28:39+00:00

[ Upstream commit d3ba32162488283c0a4c5bedd8817aec91748802 ] Make the addrs_lock be per port, not per ipvlan dev. Initial code seems to be written in the assumption, that any address change must occur under RTNL. But it is not so for the case of IPv6. So 1) Introduce per-port addrs_lock. 2) It was needed to fix places where it was forgotten to take lock (ipvlan_open/ipvlan_close) This appears to be a very minor problem though. Since it's highly unlikely that ipvlan_add_addr() will be called on 2 CPU simultaneously. But nevertheless, this could cause: 1) False-negative of ipvlan_addr_busy(): one interface iterated through all port->ipvlans + ipvlan->addrs under some ipvlan spinlock, and another added IP under its own lock. Though this is only possible for IPv6, since looks like only ipvlan_addr6_event() can be called without rtnl_lock. 2) Race since ipvlan_ht_addr_add(port) is called under different ipvlan->addrs_lock locks This should not affect performance, since add/remove IP is a rare situation and spinlock is not taken on fast paths. Fixes: 8230819494b3 ("ipvlan: use per device spinlock to protect addrs list updates") Signed-off-by: Dmitry Skorodumov Reviewed-by: Paolo Abeni Link: https://patch.msgid.link/20260112142417.4039566-2-skorodumov.dmitry@huawei.com Signed-off-by: Jakub Kicinski Signed-off-by: Sasha Levin

ipvlan: hold lower dev to avoid possible use-after-free

2022-11-18T10:39:22+00:00

Recently syzkaller discovered the issue of disappearing lower device (NETDEV_UNREGISTER) while the virtual device (like macvlan) is still having it as a lower device. So it's just a matter of time similar discovery will be made for IPvlan device setup. So fixing it preemptively. Also while at it, add a refcount tracker. Fixes: 2ad7bf363841 ("ipvlan: Initial check-in of the IPVLAN driver.") Signed-off-by: Mahesh Bandewar Signed-off-by: David S. Miller

ipvlan: adopt u64_stats_t

2022-06-10T04:53:10+00:00

As explained in commit 316580b69d0a ("u64_stats: provide u64_stats_t type") we should use u64_stats_t and related accessors to avoid load/store tearing. Add READ_ONCE() when reading rx_errs & tx_drps. Signed-off-by: Eric Dumazet Signed-off-by: Jakub Kicinski

treewide: Replace GPLv2 boilerplate/reference with SPDX - rule 152

2019-05-30T18:26:32+00:00

Based on 1 normalized pattern(s): this program is free software you can redistribute it and or modify it under the terms of the gnu general public license as published by the free software foundation either version 2 of the license or at your option any later version extracted by the scancode license scanner the SPDX license identifier GPL-2.0-or-later has been chosen to replace the boilerplate/reference in 3029 file(s). Signed-off-by: Thomas Gleixner Reviewed-by: Allison Randal Cc: linux-spdx@vger.kernel.org Link: https://lkml.kernel.org/r/20190527070032.746973796@linutronix.de Signed-off-by: Greg Kroah-Hartman

ipvlan: decouple l3s mode dependencies from other modes

2019-02-08T19:16:48+00:00

Right now ipvlan has a hard dependency on CONFIG_NETFILTER and otherwise it cannot be built. However, the only ipvlan operation mode that actually depends on netfilter is l3s, everything else is independent of it. Break this hard dependency such that users are able to use ipvlan l3 mode on systems where netfilter is not compiled in. Therefore, this adds a hidden CONFIG_IPVLAN_L3S bool which is defaulting to y when CONFIG_NETFILTER is set in order to retain existing behavior for l3s. All l3s related code is refactored into ipvlan_l3s.c that is compiled in when enabled. Signed-off-by: Daniel Borkmann Cc: Mahesh Bandewar Cc: Florian Westphal Cc: Martynas Pumputis Acked-by: Florian Westphal Signed-off-by: David S. Miller

ipvlan: properly annotate rx_handler access

2018-03-08T16:12:43+00:00

The rx_handler field is rcu-protected, but I forgot to use the proper accessor while refactoring netif_is_ipvlan_port(). Such function only check the rx_handler value, so it is safe, but we need to properly read rx_handler via rcu_access_pointer() to avoid sparse warnings. Fixes: 1ec54cb44e67 ("net: unpollute priv_flags space") Signed-off-by: Paolo Abeni Signed-off-by: David S. Miller

net: unpollute priv_flags space

2018-03-07T17:38:24+00:00

the ipvlan device driver defines and uses 2 bits inside the priv_flags net_device field. Such bits and the related helper are used only inside the ipvlan device driver, and the core networking does not need to be aware of them. This change moves netif_is_ipvlan* helper in the ipvlan driver and re-implement them looking for ipvlan specific symbols instead of using priv_flags. Overall this frees two bits inside priv_flags - and move the following ones to avoid gaps - without any intended functional change. Signed-off-by: Paolo Abeni Signed-off-by: David S. Miller

ipvlan: use per device spinlock to protect addrs list updates

2018-02-28T17:20:13+00:00

This changeset moves ipvlan address under RCU protection, using a per ipvlan device spinlock to protect list mutation and RCU read access to protect list traversal. Also explicitly use RCU read lock to traverse the per port ipvlans list, so that we can now perform a full address lookup without asserting the RTNL lock. Overall this allows the ipvlan driver to check fully for duplicate addresses - before this commit ipv6 addresses assigned by autoconf via prefix delegation where accepted without any check - and avoid the following rntl assertion failure still in the same code path: RTNL: assertion failed at drivers/net/ipvlan/ipvlan_core.c (124) WARNING: CPU: 15 PID: 0 at drivers/net/ipvlan/ipvlan_core.c:124 ipvlan_addr_busy+0x97/0xa0 [ipvlan] Modules linked in: ipvlan(E) ixgbe CPU: 15 PID: 0 Comm: swapper/15 Tainted: G E 4.16.0-rc2.ipvlan+ #1782 Hardware name: Dell Inc. PowerEdge R730/072T6D, BIOS 2.1.7 06/16/2016 RIP: 0010:ipvlan_addr_busy+0x97/0xa0 [ipvlan] RSP: 0018:ffff881ff9e03768 EFLAGS: 00010286 RAX: 0000000000000000 RBX: ffff881fdf2a9000 RCX: 0000000000000000 RDX: 0000000000000001 RSI: 00000000000000f6 RDI: 0000000000000300 RBP: ffff881fdf2a8000 R08: 0000000000000000 R09: 0000000000000000 R10: 0000000000000001 R11: ffff881ff9e034c0 R12: ffff881fe07bcc00 R13: 0000000000000001 R14: ffffffffa02002b0 R15: 0000000000000001 FS: 0000000000000000(0000) GS:ffff881ff9e00000(0000) knlGS:0000000000000000 CS: 0010 DS: 0000 ES: 0000 CR0: 0000000080050033 CR2: 00007fc5c1a4f248 CR3: 000000207e012005 CR4: 00000000001606e0 Call Trace: ipvlan_addr6_event+0x6c/0xd0 [ipvlan] notifier_call_chain+0x49/0x90 atomic_notifier_call_chain+0x6a/0x100 ipv6_add_addr+0x5f9/0x720 addrconf_prefix_rcv_add_addr+0x244/0x3c0 addrconf_prefix_rcv+0x2f3/0x790 ndisc_router_discovery+0x633/0xb70 ndisc_rcv+0x155/0x180 icmpv6_rcv+0x4ac/0x5f0 ip6_input_finish+0x138/0x6a0 ip6_input+0x41/0x1f0 ipv6_rcv+0x4db/0x8d0 __netif_receive_skb_core+0x3d5/0xe40 netif_receive_skb_internal+0x89/0x370 napi_gro_receive+0x14f/0x1e0 ixgbe_clean_rx_irq+0x4ce/0x1020 [ixgbe] ixgbe_poll+0x31a/0x7a0 [ixgbe] net_rx_action+0x296/0x4f0 __do_softirq+0xcf/0x4f5 irq_exit+0xf5/0x110 do_IRQ+0x62/0x110 common_interrupt+0x91/0x91 v1 -> v2: drop unneeded in_softirq check in ipvlan_addr6_validator_event() Fixes: e9997c2938b2 ("ipvlan: fix check for IP addresses in control path") Signed-off-by: Paolo Abeni Signed-off-by: David S. Miller

ipvlan: implement VEPA mode

2017-10-29T09:39:57+00:00

This is very similar to the Macvlan VEPA mode, however, there is some difference. IPvlan uses the mac-address of the lower device, so the VEPA mode has implications of ICMP-redirects for packets destined for its immediate neighbors sharing same master since the packets will have same source and dest mac. The external switch/router will send redirect msg. Having said that, this will be useful tool in terms of debugging since IPvlan will not switch packets within its slaves and rely completely on the external entity as intended in 802.1Qbg. Signed-off-by: Mahesh Bandewar Signed-off-by: David S. Miller

ipvlan: introduce 'private' attribute for all existing modes.

2017-10-29T09:39:57+00:00

IPvlan has always operated in bridge mode. However there are scenarios where each slave should be able to talk through the master device but not necessarily across each other. Think of an environment where each of a namespace is a private and independant customer. In this scenario the machine which is hosting these namespaces neither want to tell who their neighbor is nor the individual namespaces care to talk to neighbor on short-circuited network path. This patch implements the mode that is very similar to the 'private' mode in macvlan where individual slaves can send and receive traffic through the master device, just that they can not talk among slave devices. Signed-off-by: Mahesh Bandewar Signed-off-by: David S. Miller