kernel/linux.git/drivers/leds/Makefile, branch linux-5.9.y

leds: initial support for Turris Omnia LEDs

2020-07-24T10:58:55+00:00

This adds basic support for LEDs on the front side of CZ.NIC's Turris Omnia router. There are 12 RGB LEDs. The controller supports HW triggering mode for the LEDs, but this driver does not support it yet, and sets all the LEDs defined in device-tree into SW mode upon probe. This driver uses the multicolor LED framework. Signed-off-by: Marek Behún Reviewed-by: Dan Murphy Signed-off-by: Pavel Machek

leds: multicolor: Introduce a multicolor class definition

2020-07-22T12:41:29+00:00

Introduce a multicolor class that groups colored LEDs within a LED node. The multicolor class groups monochrome LEDs and allows controlling two aspects of the final combined color: hue and lightness. The former is controlled via the intensity file and the latter is controlled via brightness file. Signed-off-by: Dan Murphy Acked-by: Jacek Anaszewski Signed-off-by: Pavel Machek [squashed leds: multicolor: Fix camel case in documentation in]

leds: add aw2013 driver

2020-05-25T10:56:39+00:00

This commit adds support for AWINIC AW2013 3-channel LED driver. The chip supports 3 PWM channels and is controlled with I2C. Signed-off-by: Nikita Travkin Signed-off-by: Pavel Machek

leds: add sgm3140 driver

2020-04-27T09:44:51+00:00

Add a driver for the SGMICRO SGM3140 Buck/Boost Charge Pump LED driver. This device is controlled by two GPIO pins, one for enabling and the second one for switching between torch and flash mode. Signed-off-by: Luca Weiss Signed-off-by: Pavel Machek

leds: ariel: Add driver for status LEDs on Dell Wyse 3020

2020-04-27T09:35:11+00:00

This adds support for controlling the LEDs attached to the Embedded Controller on a Dell Wyse 3020 "Ariel" board. Signed-off-by: Lubomir Rintel Signed-off-by: Pavel Machek

leds: sort Makefile entries

2020-04-06T20:57:10+00:00

Sort Makefile entries to reduce risk of rejects. Signed-off-by: Pavel Machek

leds: add SGI IP30 led support

2020-02-26T20:49:32+00:00

This patch implemenets a driver to support the front panel LEDs of SGI Octane (IP30) workstations. Reviewed-by: Dan Murphy Signed-off-by: Thomas Bogendoerfer Acked-by: Jacek Anaszewski Signed-off-by: Pavel Machek

leds: tps6105x: add driver for MFD chip LED mode

2019-12-21T19:10:02+00:00

This driver adds support for the LED operational mode of the tps6105x MFD device. Acked-by: Jacek Anaszewski Signed-off-by: Sven Van Asbroeck Signed-off-by: Pavel Machek

leds: add LED driver for EL15203000 board

2019-11-03T16:37:06+00:00

This patch adds a LED class driver for the LEDs found on the Crane Merchandising System EL15203000 LEDs board (aka RED LEDs board). Signed-off-by: Oleh Kravchenko Reviewed-by: Dan Murphy Signed-off-by: Pavel Machek

Merge tag 'ti-lmu-led-drivers' into for-next

2019-06-11T21:46:37+00:00

Merge immutable branch between LEDs, MFD and REGULATOR due to TI LMU LED support rework and introduction of two new drivers with DT bindings. * tag 'ti-lmu-led-drivers': leds: lm36274: Introduce the TI LM36274 LED driver dt-bindings: leds: Add LED bindings for the LM36274 regulator: lm363x: Add support for LM36274 mfd: ti-lmu: Add LM36274 support to the ti-lmu dt-bindings: mfd: Add lm36274 bindings to ti-lmu leds: lm3697: Introduce the lm3697 driver mfd: ti-lmu: Remove support for LM3697 dt-bindings: ti-lmu: Modify dt bindings for the LM3697 leds: TI LMU: Add common code for TI LMU devices dt-bindings: mfd: LMU: Add ti,brightness-resolution dt-bindings: mfd: LMU: Add the ramp up/down property