kernel/linux.git/drivers/input/touchscreen, branch v5.4.201

Input: stmfts - do not leave device disabled in stmfts_input_open

2022-06-14T16:11:42+00:00

[ Upstream commit 5f76955ab1e43e5795a9631b22ca4f918a0ae986 ] The commit 26623eea0da3 attempted to deal with potential leak of runtime PM counter when opening the touchscreen device, however it ended up erroneously dropping the counter in the case of successfully enabling the device. Let's address this by using pm_runtime_resume_and_get() and then executing pm_runtime_put_sync() only when we fail to send "sense on" command to the device. Fixes: 26623eea0da3 ("Input: stmfts - fix reference leak in stmfts_input_open") Reported-by: Pavel Machek Signed-off-by: Dmitry Torokhov Signed-off-by: Sasha Levin

Input: goodix - fix spurious key release events

2022-06-06T06:33:48+00:00

commit 24ef83f6e31d20fc121a7cd732b04b498475fca3 upstream. The goodix panel sends spurious interrupts after a 'finger up' event, which always cause a timeout. We were exiting the interrupt handler by reporting touch_num == 0, but this was still processed as valid and caused the code to use the uninitialised point_data, creating spurious key release events. Report an error from the interrupt handler so as to avoid processing invalid point_data further. Signed-off-by: Dmitry Mastykin Reviewed-by: Bastien Nocera Link: https://lore.kernel.org/r/20200316075302.3759-2-dmastykin@astralinux.ru Signed-off-by: Dmitry Torokhov Cc: Fabio Estevam Signed-off-by: Greg Kroah-Hartman

Input: ili210x - fix reset timing

2022-05-25T07:14:38+00:00

commit e4920d42ce0e9c8aafb7f64b6d9d4ae02161e51e upstream. According to Ilitek "231x & ILI251x Programming Guide" Version: 2.30 "2.1. Power Sequence", "T4 Chip Reset and discharge time" is minimum 10ms and "T2 Chip initial time" is maximum 150ms. Adjust the reset timings such that T4 is 12ms and T2 is 160ms to fit those figures. This prevents sporadic touch controller start up failures when some systems with at least ILI251x controller boot, without this patch the systems sometimes fail to communicate with the touch controller. Fixes: 201f3c803544c ("Input: ili210x - add reset GPIO support") Signed-off-by: Marek Vasut Link: https://lore.kernel.org/r/20220518204901.93534-1-marex@denx.de Cc: stable@vger.kernel.org Signed-off-by: Dmitry Torokhov Signed-off-by: Greg Kroah-Hartman

Input: stmfts - fix reference leak in stmfts_input_open

2022-05-25T07:14:32+00:00

[ Upstream commit 26623eea0da3476446909af96c980768df07bbd9 ] pm_runtime_get_sync() will increment pm usage counter even it failed. Forgetting to call pm_runtime_put_noidle will result in reference leak in stmfts_input_open, so we should fix it. Signed-off-by: Zheng Yongjun Link: https://lore.kernel.org/r/20220317131604.53538-1-zhengyongjun3@huawei.com Signed-off-by: Dmitry Torokhov Signed-off-by: Sasha Levin

Input: touchscreen - Fix backport of a02dcde595f7cbd240ccd64de96034ad91cffc40

2022-01-11T14:23:30+00:00

Upstream commit a02dcde595f7 ("Input: touchscreen - avoid bitwise vs logical OR warning") was applied as commit f6e9e7be9b80 ("Input: touchscreen - avoid bitwise vs logical OR warning") in linux-5.4.y but it did not properly account for commit d9265e8a878a ("Input: of_touchscreen - add support for touchscreen-min-x|y"), which means the warning mentioned in the commit message is not fully fixed: drivers/input/touchscreen/of_touchscreen.c:78:17: warning: use of bitwise '|' with boolean operands [-Wbitwise-instead-of-logical] data_present = touchscreen_get_prop_u32(dev, "touchscreen-min-x", ^~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ drivers/input/touchscreen/of_touchscreen.c:78:17: note: cast one or both operands to int to silence this warning drivers/input/touchscreen/of_touchscreen.c:92:17: warning: use of bitwise '|' with boolean operands [-Wbitwise-instead-of-logical] data_present = touchscreen_get_prop_u32(dev, "touchscreen-min-y", ^~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ drivers/input/touchscreen/of_touchscreen.c:92:17: note: cast one or both operands to int to silence this warning 2 warnings generated. It seems like the 4.19 backport was applied to the 5.4 tree, which did not have any conflicts so no issue was noticed at that point. Fix up the backport to bring it more in line with the upstream version so that there is no warning. Fixes: f6e9e7be9b80 ("Input: touchscreen - avoid bitwise vs logical OR warning") Signed-off-by: Nathan Chancellor Signed-off-by: Greg Kroah-Hartman

Input: atmel_mxt_ts - fix double free in mxt_read_info_block

2021-12-29T11:23:36+00:00

commit 12f247ab590a08856441efdbd351cf2cc8f60a2d upstream. The "id_buf" buffer is stored in "data->raw_info_block" and freed by "mxt_free_object_table" in case of error. Return instead of jumping to avoid a double free. Addresses-Coverity-ID: 1474582 ("Double free") Fixes: 068bdb67ef74 ("Input: atmel_mxt_ts - fix the firmware update") Signed-off-by: José Expósito Link: https://lore.kernel.org/r/20211212194257.68879-1-jose.exposito89@gmail.com Cc: stable@vger.kernel.org Signed-off-by: Dmitry Torokhov Signed-off-by: Greg Kroah-Hartman

Input: touchscreen - avoid bitwise vs logical OR warning

2021-12-22T08:29:39+00:00

commit a02dcde595f7cbd240ccd64de96034ad91cffc40 upstream. A new warning in clang points out a few places in this driver where a bitwise OR is being used with boolean types: drivers/input/touchscreen.c:81:17: warning: use of bitwise '|' with boolean operands [-Wbitwise-instead-of-logical] data_present = touchscreen_get_prop_u32(dev, "touchscreen-min-x", ^~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ This use of a bitwise OR is intentional, as bitwise operations do not short circuit, which allows all the calls to touchscreen_get_prop_u32() to happen so that the last parameter is initialized while coalescing the results of the calls to make a decision after they are all evaluated. To make this clearer to the compiler, use the '|=' operator to assign the result of each touchscreen_get_prop_u32() call to data_present, which keeps the meaning of the code the same but makes it obvious that every one of these calls is expected to happen. Signed-off-by: Nathan Chancellor Reported-by: Nick Desaulniers Reviewed-by: Nick Desaulniers Link: https://lore.kernel.org/r/20211014205757.3474635-1-nathan@kernel.org Signed-off-by: Dmitry Torokhov Signed-off-by: Anders Roxell Signed-off-by: Greg Kroah-Hartman

Input: hideep - fix the uninitialized use in hideep_nvm_unlock()

2021-07-20T14:10:45+00:00

[ Upstream commit cac7100d4c51c04979dacdfe6c9a5e400d3f0a27 ] Inside function hideep_nvm_unlock(), variable "unmask_code" could be uninitialized if hideep_pgm_r_reg() returns error, however, it is used in the later if statement after an "and" operation, which is potentially unsafe. Signed-off-by: Yizhuo Signed-off-by: Dmitry Torokhov Signed-off-by: Sasha Levin

Input: usbtouchscreen - fix control-request directions

2021-07-14T14:53:00+00:00

commit 41e81022a04a0294c55cfa7e366bc14b9634c66e upstream. The direction of the pipe argument must match the request-type direction bit or control requests may fail depending on the host-controller-driver implementation. Fix the four control requests which erroneously used usb_rcvctrlpipe(). Fixes: 1d3e20236d7a ("[PATCH] USB: usbtouchscreen: unified USB touchscreen driver") Fixes: 24ced062a296 ("usbtouchscreen: add support for DMC TSC-10/25 devices") Fixes: 9e3b25837a20 ("Input: usbtouchscreen - add support for e2i touchscreen controller") Signed-off-by: Johan Hovold Cc: stable@vger.kernel.org # 2.6.17 Link: https://lore.kernel.org/r/20210524092048.4443-1-johan@kernel.org Signed-off-by: Dmitry Torokhov Signed-off-by: Greg Kroah-Hartman

Input: silead - add workaround for x86 BIOS-es which bring the chip up in a stuck state

2021-05-22T09:38:28+00:00

[ Upstream commit e479187748a8f151a85116a7091c599b121fdea5 ] Some buggy BIOS-es bring up the touchscreen-controller in a stuck state where it blocks the I2C bus. Specifically this happens on the Jumper EZpad 7 tablet model. After much poking at this problem I have found that the following steps are necessary to unstuck the chip / bus: 1. Turn off the Silead chip. 2. Try to do an I2C transfer with the chip, this will fail in response to which the I2C-bus-driver will call: i2c_recover_bus() which will unstuck the I2C-bus. Note the unstuck-ing of the I2C bus only works if we first drop the chip of the bus by turning it off. 3. Turn the chip back on. On the x86/ACPI systems were this problem is seen, step 1. and 3. require making ACPI calls and dealing with ACPI Power Resources. This commit adds a workaround which runtime-suspends the chip to turn it off, leaving it up to the ACPI subsystem to deal with all the ACPI specific details. There is no good way to detect this bug, so the workaround gets activated by a new "silead,stuck-controller-bug" boolean device-property. Since this is only used on x86/ACPI, this will be set by model specific device-props set by drivers/platform/x86/touchscreen_dmi.c. Therefor this new device-property is not documented in the DT-bindings. Dmesg will contain the following messages on systems where the workaround is activated: [ 54.309029] silead_ts i2c-MSSL1680:00: [Firmware Bug]: Stuck I2C bus: please ignore the next 'controller timed out' error [ 55.373593] i2c_designware 808622C1:04: controller timed out [ 55.582186] silead_ts i2c-MSSL1680:00: Silead chip ID: 0x80360000 Signed-off-by: Hans de Goede Link: https://lore.kernel.org/r/20210405202745.16777-1-hdegoede@redhat.com Signed-off-by: Dmitry Torokhov Signed-off-by: Sasha Levin