kernel/linux.git/drivers/gpu/drm/vc4, branch v4.9.4

drm/vc4: Add support for double-clocked modes.

2016-10-06T18:58:28+00:00

Now that we have infoframes to report the pixel repeat flag, we can start using it. Fixes locking the 720x480i and 720x576i modes on my Dell 2408WFP. Like the 1920x1080i case, they don't fit properly on the screen, though. Signed-off-by: Eric Anholt

drm/vc4: Set up the AVI and SPD infoframes.

2016-10-06T18:58:28+00:00

Fixes a purple bar on the left side of the screen with my Dell 2408WFP. It will also be required for supporting the double-clocked video modes. Signed-off-by: Eric Anholt

drm/vc4: Fix support for interlaced modes on HDMI.

2016-10-06T18:58:27+00:00

We really do need to be using the halved V fields. I had been confused by the code I was using as a reference because it stored halved vsync fields but not halved vdisplay, so it looked like I only needed to divide vdisplay by 2. This reverts part of Mario's timestamping fixes that prevented CRTC_HALVE_V from applying, and instead adjusts the timestamping code to not use the crtc field in that case. Fixes locking of 1920x1080x60i on my Dell 2408WFP. There are black bars on the top and bottom, but I suspect that might be an under/overscan flags problem as opposed to video timings. Signed-off-by: Eric Anholt

drm/vc4: Increase timeout for HDMI_SCHEDULER_CONTROL changes.

2016-10-06T18:58:27+00:00

Fixes occasional debug spew at boot when connected directly through HDMI, and probably confusing the HDMI state machine when we go trying to poke registers for the enable sequence too soon. Signed-off-by: Eric Anholt

drm/vc4: Fall back to using an EDID probe in the absence of a GPIO.

2016-10-06T18:58:26+00:00

On Pi0/1/2, we use an external GPIO line for hotplug detection, since the HDMI_HOTPLUG register isn't connected to anything. However, with the Pi3 the HPD GPIO line has moved off to a GPIO expander that will be tricky to get to (the firmware is constantly polling the expander using i2c0, so we'll need to coordinate with it). As a stop-gap, if we don't have a GPIO line, use an EDID probe to detect connection. Fixes HDMI display on the pi3. Signed-off-by: Eric Anholt

drm/vc4: Enable limited range RGB output on HDMI with CEA modes.

2016-10-06T18:58:26+00:00

Fixes broken grayscale ramps on many HDMI monitors, where large areas at the ends of the ramp would all appear as black or white. Signed-off-by: Eric Anholt

drm/vc4: Fix races when the CS reads from render targets.

2016-10-06T18:53:50+00:00

With the introduction of bin/render pipelining, the previous job may not be completed when we start binning the next one. If the previous job wrote our VBO, IB, or CS textures, then the binning stage might get stale or uninitialized results. Fixes the major rendering failure in glmark2 -b terrain. Signed-off-by: Eric Anholt Fixes: ca26d28bbaa3 ("drm/vc4: improve throughput by pipelining binning and rendering jobs") Cc: stable@vger.kernel.org

drm/vc4: cleanup with list_first_entry_or_null()

2016-10-06T18:53:35+00:00

The combo of list_empty() check and return list_first_entry() can be replaced with list_first_entry_or_null(). Signed-off-by: Masahiro Yamada Signed-off-by: Eric Anholt

Merge tag 'v4.8-rc8' into drm-next

2016-09-28T02:08:49+00:00

Linux 4.8-rc8 There was a lot of fallout in the imx/amdgpu/i915 drivers, so backmerge it now to avoid troubles. * tag 'v4.8-rc8': (1442 commits) Linux 4.8-rc8 fault_in_multipages_readable() throws set-but-unused error mm: check VMA flags to avoid invalid PROT_NONE NUMA balancing radix tree: fix sibling entry handling in radix_tree_descend() radix tree test suite: Test radix_tree_replace_slot() for multiorder entries fix memory leaks in tracing_buffers_splice_read() tracing: Move mutex to protect against resetting of seq data MIPS: Fix delay slot emulation count in debugfs MIPS: SMP: Fix possibility of deadlock when bringing CPUs online mm: delete unnecessary and unsafe init_tlb_ubc() huge tmpfs: fix Committed_AS leak shmem: fix tmpfs to handle the huge= option properly blk-mq: skip unmapped queues in blk_mq_alloc_request_hctx MIPS: Fix pre-r6 emulation FPU initialisation arm64: kgdb: handle read-only text / modules arm64: Call numa_store_cpu_info() earlier. locking/hung_task: Fix typo in CONFIG_DETECT_HUNG_TASK help text nvme-rdma: only clear queue flags after successful connect i2c: qup: skip qup_i2c_suspend if the device is already runtime suspended perf/core: Limit matching exclusive events to one PMU ...

drm: Don't swallow error codes in drm_dev_alloc()

2016-09-22T11:03:48+00:00

There are many reasons other than ENOMEM that drm_dev_init() can fail. Return ERR_PTR rather than NULL to be able to distinguish these in the caller. Signed-off-by: Tom Gundersen Signed-off-by: Sean Paul Link: http://patchwork.freedesktop.org/patch/msgid/20160921145919.13754-2-teg@jklm.no