kernel/linux.git/drivers/bluetooth/btrtl.c, branch v6.19.11

Bluetooth: btrtl: Add the support for RTL8761CUV

2025-12-01T21:00:07+00:00

Add support for RTL8761CUV BT controller on the USB interface. Do not apply IC_MATCH_FL_HCIVER when hci_ver is 0 in the ic_id_table. The device info from /sys/kernel/debug/usb/devices as below. T: Bus=02 Lev=01 Prnt=01 Port=00 Cnt=01 Dev#= 13 Spd=12 MxCh= 0 D: Ver= 1.10 Cls=e0(wlcon) Sub=01 Prot=01 MxPS=64 #Cfgs= 1 P: Vendor=0bda ProdID=c761 Rev= 2.00 S: Manufacturer=Realtek S: Product=Bluetooth Controller S: SerialNumber=10000 C:* #Ifs= 2 Cfg#= 1 Atr=a0 MxPwr=100mA I:* If#= 0 Alt= 0 #EPs= 3 Cls=e0(wlcon) Sub=01 Prot=01 Driver=btusb E: Ad=81(I) Atr=03(Int.) MxPS= 64 Ivl=1ms E: Ad=02(O) Atr=02(Bulk) MxPS= 64 Ivl=0ms E: Ad=82(I) Atr=02(Bulk) MxPS= 64 Ivl=0ms I:* If#= 1 Alt= 0 #EPs= 2 Cls=e0(wlcon) Sub=01 Prot=01 Driver=btusb E: Ad=83(I) Atr=01(Isoc) MxPS= 0 Ivl=1ms E: Ad=03(O) Atr=01(Isoc) MxPS= 0 Ivl=1ms I: If#= 1 Alt= 1 #EPs= 2 Cls=e0(wlcon) Sub=01 Prot=01 Driver=btusb E: Ad=83(I) Atr=01(Isoc) MxPS= 9 Ivl=1ms E: Ad=03(O) Atr=01(Isoc) MxPS= 9 Ivl=1ms I: If#= 1 Alt= 2 #EPs= 2 Cls=e0(wlcon) Sub=01 Prot=01 Driver=btusb E: Ad=83(I) Atr=01(Isoc) MxPS= 17 Ivl=1ms E: Ad=03(O) Atr=01(Isoc) MxPS= 17 Ivl=1ms I: If#= 1 Alt= 3 #EPs= 2 Cls=e0(wlcon) Sub=01 Prot=01 Driver=btusb E: Ad=83(I) Atr=01(Isoc) MxPS= 25 Ivl=1ms E: Ad=03(O) Atr=01(Isoc) MxPS= 25 Ivl=1ms I: If#= 1 Alt= 4 #EPs= 2 Cls=e0(wlcon) Sub=01 Prot=01 Driver=btusb E: Ad=83(I) Atr=01(Isoc) MxPS= 33 Ivl=1ms E: Ad=03(O) Atr=01(Isoc) MxPS= 33 Ivl=1ms I: If#= 1 Alt= 5 #EPs= 2 Cls=e0(wlcon) Sub=01 Prot=01 Driver=btusb E: Ad=83(I) Atr=01(Isoc) MxPS= 49 Ivl=1ms E: Ad=03(O) Atr=01(Isoc) MxPS= 49 Ivl=1ms I: If#= 1 Alt= 6 #EPs= 2 Cls=e0(wlcon) Sub=01 Prot=01 Driver=btusb E: Ad=83(I) Atr=01(Isoc) MxPS= 63 Ivl=1ms E: Ad=03(O) Atr=01(Isoc) MxPS= 63 Ivl=1ms Signed-off-by: Max Chou Signed-off-by: Luiz Augusto von Dentz

Bluetooth: btrtl: Avoid loading the config file on security chips

2025-11-11T14:06:57+00:00

For chips with security enabled, it's only possible to load firmware with a valid signature pattern. If key_id is not zero, it indicates a security chip, and the driver will not load the config file. - Example log for a security chip. Bluetooth: hci0: RTL: examining hci_ver=0c hci_rev=000a lmp_ver=0c lmp_subver=8922 Bluetooth: hci0: RTL: rom_version status=0 version=1 Bluetooth: hci0: RTL: btrtl_initialize: key id 1 Bluetooth: hci0: RTL: loading rtl_bt/rtl8922au_fw.bin Bluetooth: hci0: RTL: cfg_sz 0, total sz 71301 Bluetooth: hci0: RTL: fw version 0x41c0c905 - Example log for a normal chip. Bluetooth: hci0: RTL: examining hci_ver=0c hci_rev=000a lmp_ver=0c lmp_subver=8922 Bluetooth: hci0: RTL: rom_version status=0 version=1 Bluetooth: hci0: RTL: btrtl_initialize: key id 0 Bluetooth: hci0: RTL: loading rtl_bt/rtl8922au_fw.bin Bluetooth: hci0: RTL: loading rtl_bt/rtl8922au_config.bin Bluetooth: hci0: RTL: cfg_sz 6, total sz 71307 Bluetooth: hci0: RTL: fw version 0x41c0c905 Tested-by: Hilda Wu Signed-off-by: Nial Ni Signed-off-by: Max Chou Signed-off-by: Luiz Augusto von Dentz

Bluetooth: btrtl: Fix memory leak in rtlbt_parse_firmware_v2()

2025-10-31T16:42:47+00:00

The memory allocated for ptr using kvmalloc() is not freed on the last error path. Fix that by freeing it on that error path. Fixes: 9a24ce5e29b1 ("Bluetooth: btrtl: Firmware format v2 support") Signed-off-by: Abdun Nihaal Signed-off-by: Luiz Augusto von Dentz

Bluetooth: btrtl: Fix typo in comment

2025-07-23T14:29:50+00:00

Found by codespell. Signed-off-by: Bastien Nocera Signed-off-by: Luiz Augusto von Dentz

Bluetooth: hci_dev: replace 'quirks' integer by 'quirk_flags' bitmap

2025-07-16T19:37:53+00:00

The 'quirks' member already ran out of bits on some platforms some time ago. Replace the integer member by a bitmap in order to have enough bits in future. Replace raw bit operations by accessor macros. Fixes: ff26b2dd6568 ("Bluetooth: Add quirk for broken READ_VOICE_SETTING") Fixes: 127881334eaa ("Bluetooth: Add quirk for broken READ_PAGE_SCAN_TYPE") Suggested-by: Pauli Virtanen Tested-by: Ivan Pravdin Signed-off-by: Kiran K Signed-off-by: Christian Eggers Signed-off-by: Luiz Augusto von Dentz

Bluetooth: btrtl: Prevent potential NULL dereference

2025-04-10T17:09:16+00:00

The btrtl_initialize() function checks that rtl_load_file() either had an error or it loaded a zero length file. However, if it loaded a zero length file then the error code is not set correctly. It results in an error pointer vs NULL bug, followed by a NULL pointer dereference. This was detected by Smatch: drivers/bluetooth/btrtl.c:592 btrtl_initialize() warn: passing zero to 'ERR_PTR' Fixes: 26503ad25de8 ("Bluetooth: btrtl: split the device initialization into smaller parts") Signed-off-by: Dan Carpenter Reviewed-by: Hans de Goede Signed-off-by: Luiz Augusto von Dentz

Bluetooth: btrtl: check for NULL in btrtl_setup_realtek()

2025-01-15T15:34:41+00:00

If insert an USB dongle which chip is not maintained in ic_id_table, it will hit the NULL point accessed. Add a null point check to avoid the Kernel Oops. Fixes: b39910bb54d9 ("Bluetooth: Populate hci_set_hw_info for Intel and Realtek") Reviewed-by: Alex Lu Signed-off-by: Max Chou Signed-off-by: Luiz Augusto von Dentz

Bluetooth: btrtl: Decrease HCI_OP_RESET timeout from 10 s to 2 s

2024-11-14T20:35:57+00:00

The original timeout setting for HCI Reset on shutdown is 10 seconds. HCI Reset shouldn't take 10 seconds to complete so instead use the default timeout for commands. Signed-off-by: Hilda Wu Signed-off-by: Luiz Augusto von Dentz

move asm/unaligned.h to linux/unaligned.h

2024-10-02T21:23:23+00:00

asm/unaligned.h is always an include of asm-generic/unaligned.h; might as well move that thing to linux/unaligned.h and include that - there's nothing arch-specific in that header. auto-generated by the following: for i in `git grep -l -w asm/unaligned.h`; do sed -i -e "s/asm\/unaligned.h/linux\/unaligned.h/" $i done for i in `git grep -l -w asm-generic/unaligned.h`; do sed -i -e "s/asm-generic\/unaligned.h/linux\/unaligned.h/" $i done git mv include/asm-generic/unaligned.h include/linux/unaligned.h git mv tools/include/asm-generic/unaligned.h tools/include/linux/unaligned.h sed -i -e "/unaligned.h/d" include/asm-generic/Kbuild sed -i -e "s/__ASM_GENERIC/__LINUX/" include/linux/unaligned.h tools/include/linux/unaligned.h

Bluetooth: btrtl: Set msft ext address filter quirk for RTL8852B

2024-09-10T17:06:24+00:00

For tracking multiple devices concurrently with a condition. The patch enables the HCI_QUIRK_USE_MSFT_EXT_ADDRESS_FILTER quirk on RTL8852B controller. The quirk setting is based on commit 9e14606d8f38 ("Bluetooth: msft: Extended monitor tracking by address filter") With this setting, when a pattern monitor detects a device, this feature issues an address monitor for tracking that device. Let the original pattern monitor keep monitor new devices. Signed-off-by: Hilda Wu Signed-off-by: Luiz Augusto von Dentz