diff options
Diffstat (limited to 'Documentation/devicetree/bindings/serial/fsl-imx-uart.txt')
| -rw-r--r-- | Documentation/devicetree/bindings/serial/fsl-imx-uart.txt | 6 |
1 files changed, 5 insertions, 1 deletions
diff --git a/Documentation/devicetree/bindings/serial/fsl-imx-uart.txt b/Documentation/devicetree/bindings/serial/fsl-imx-uart.txt index afcfbc34e243..35957cbf1571 100644 --- a/Documentation/devicetree/bindings/serial/fsl-imx-uart.txt +++ b/Documentation/devicetree/bindings/serial/fsl-imx-uart.txt @@ -9,7 +9,11 @@ Optional properties: - fsl,dte-mode : Indicate the uart works in DTE mode. The uart works in DCE mode by default. - rs485-rts-delay, rs485-rts-active-low, rs485-rx-during-tx, - linux,rs485-enabled-at-boot-time: see rs485.txt + linux,rs485-enabled-at-boot-time: see rs485.txt. Note that for RS485 + you must enable either the "uart-has-rtscts" or the "rts-gpios" + properties. In case you use "uart-has-rtscts" the signal that controls + the transceiver is actually CTS_B, not RTS_B. CTS_B is always output, + and RTS_B is input, regardless of dte-mode. Please check Documentation/devicetree/bindings/serial/serial.txt for the complete list of generic properties. |