1 files changed, 1 insertions, 89 deletions
diff --git a/Documentation/devicetree/bindings/eeprom/at24.txt b/Documentation/devicetree/bindings/eeprom/at24.txt
index 22aead844d0f..c94acbb8cb0c 100644
--- a/Documentation/devicetree/bindings/eeprom/at24.txt
+++ b/Documentation/devicetree/bindings/eeprom/at24.txt
@@ -1,89 +1 @@
-EEPROMs (I2C)
-
-Required properties:
-
-  - compatible: Must be a "<manufacturer>,<model>" pair. The following <model>
-                values are supported (assuming "atmel" as manufacturer):
-
-                "atmel,24c00",
-                "atmel,24c01",
-                "atmel,24cs01",
-                "atmel,24c02",
-                "atmel,24cs02",
-                "atmel,24mac402",
-                "atmel,24mac602",
-                "atmel,spd",
-                "atmel,24c04",
-                "atmel,24cs04",
-                "atmel,24c08",
-                "atmel,24cs08",
-                "atmel,24c16",
-                "atmel,24cs16",
-                "atmel,24c32",
-                "atmel,24cs32",
-                "atmel,24c64",
-                "atmel,24cs64",
-                "atmel,24c128",
-                "atmel,24c256",
-                "atmel,24c512",
-                "atmel,24c1024",
-                "atmel,24c2048",
-
-                If <manufacturer> is not "atmel", then a fallback must be used
-                with the same <model> and "atmel" as manufacturer.
-
-                Example:
-                        compatible = "microchip,24c128", "atmel,24c128";
-
-                Supported manufacturers are:
-
-                "catalyst",
-                "microchip",
-                "nxp",
-                "ramtron",
-                "renesas",
-                "rohm",
-                "st",
-
-                Some vendors use different model names for chips which are just
-                variants of the above. Known such exceptions are listed below:
-
-                "nxp,se97b" - the fallback is "atmel,24c02",
-                "renesas,r1ex24002" - the fallback is "atmel,24c02"
-                "renesas,r1ex24016" - the fallback is "atmel,24c16"
-                "renesas,r1ex24128" - the fallback is "atmel,24c128"
-                "rohm,br24t01" - the fallback is "atmel,24c01"
-
-  - reg: The I2C address of the EEPROM.
-
-Optional properties:
-
-  - pagesize: The length of the pagesize for writing. Please consult the
-              manual of your device, that value varies a lot. A wrong value
-              may result in data loss! If not specified, a safety value of
-              '1' is used which will be very slow.
-
-  - read-only: This parameterless property disables writes to the eeprom.
-
-  - size: Total eeprom size in bytes.
-
-  - no-read-rollover: This parameterless property indicates that the
-                      multi-address eeprom does not automatically roll over
-                      reads to the next slave address. Please consult the
-                      manual of your device.
-
-  - wp-gpios: GPIO to which the write-protect pin of the chip is connected.
-
-  - address-width: number of address bits (one of 8, 16).
-
-  - num-addresses: total number of i2c slave addresses this device takes
-
-Example:
-
-eeprom@52 {
-	compatible = "atmel,24c32";
-	reg = <0x52>;
-	pagesize = <32>;
-	wp-gpios = <&gpio1 3 0>;
-	num-addresses = <8>;
-};
+This file has been moved to at24.yaml.