Merge tag 'mtd/for-4.18' of git://git.infradead.org/linux-mtd

Pull MTD updates from Boris Brezillon:
 "Core changes:
   - Add a sysfs attribute to expose available OOB size

  Driver changes:
   - Remove HAS_DMA dependency on various drivers
   - Use dev_get_drvdata() instead of platform_get_drvdata() in docg3
   - Replace msleep by usleep_range() in the dataflash driver
   - Avoid VLA usage in nftl layers
   - Remove useless .owner assignment in pismo
   - Fix various issues in the CFI driver
   - Improve TRX partition handling expose a DT compat for this part
     parser
   - Clarify OFFSET_CONTINUOUS meaning

  NAND core changes:
   - Add Miquel as a NAND maintainer
   - Add access mode to the nand_page_io_req struct
   - Fix kernel-doc in rawnand.h
   - Support bit-wise majority to recover from corrupted ONFI parameter
     pages
   - Stop checking FAIL bit after a SET_FEATURES, as documented in the
     ONFI spec

  Raw NAND Driver changes:
   - Fix and cleanup the error path of many NAND controller drivers
   - GPMI:
      + Cleanup/simplification of a few aspects in the driver
      + Take ECC setup specified in the DT into account
   - sunxi: remove support for GPIO-based R/B polling
   - MTK:
      + Use of_device_get_match_data() instead of of_match_device()
      + Add an entry in MAINTAINERS for this driver
      + Fix nand-ecc-step-size and nand-ecc-strength description in the
        DT bindings doc
   - fsl_ifc: fix ->cmdfunc() to read more than one ONFI parameter page

  OneNAND driver changes:
   - samsung: use dev_get_drvdata() instead of platform_get_drvdata()

  SPI NOR core changes:
   - Add support for a bunch of SPI NOR chips
   - Clear EAR reg when switching to 3-byte addressing mode on Winbond
     chips

  SPI NOR controller driver changes:
   - cadence: Add DMA support for direct mode reads
   - hisi: Prefix a few functions with hisi_
   - intel:
      + Mark the driver as "dangerous" in Kconfig
      + Fix atomic sequence handling
      + Pass a 40us delay (instead of 0us) to readl_poll_timeout()
   - fsl:
      + fix a typo in a function name
      + add support for IP variants embedded in the ls2080a and ls1080a
        SoCs
   - stm32: request exclusive control of the reset line"

* tag 'mtd/for-4.18' of git://git.infradead.org/linux-mtd: (66 commits)
  mtd: nand: Pass mode information to nand_page_io_req
  mtd: cfi_cmdset_0002: Change erase one block to enable XIP once
  mtd: cfi_cmdset_0002: Change erase functions to check chip good only
  mtd: cfi_cmdset_0002: Change erase functions to retry for error
  mtd: cfi_cmdset_0002: Change definition naming to retry write operation
  mtd: cfi_cmdset_0002: Change write buffer to check correct value
  mtd: cmdlinepart: Update comment for introduction of OFFSET_CONTINUOUS
  mtd: bcm47xxpart: add of_match_table with a new DT binding
  dt-bindings: mtd: document Broadcom's BCM47xx partitions
  mtd: spi-nor: Add support for EN25QH32
  mtd: spi-nor: Add support for is25wp series chips
  mtd: spi-nor: Add Winbond w25q32jv support
  mtd: spi-nor: fsl-quadspi: add support for ls2080a/ls1080a
  mtd: spi-nor: stm32-quadspi: explicitly request exclusive reset control
  mtd: spi-nor: intel: provide a range for poll_timout
  mtd: spi-nor: fsl-quadspi: fix api naming typo _init_ahb_read
  mtd: spi-nor: intel-spi: Explicitly mark the driver as dangerous in Kconfig
  mtd: spi-nor: intel-spi: Fix atomic sequence handling
  mtd: rawnand: Do not check FAIL bit when executing a SET_FEATURES op
  mtd: rawnand: use bit-wise majority to recover the ONFI param page
  ...

1 files changed, 14 insertions, 12 deletions

diff --git a/drivers/mtd/nand/raw/lpc32xx_slc.c b/drivers/mtd/nand/raw/lpc32xx_slc.c
index 5f7cc6da0a7f..42820aa1abab 100644
--- a/drivers/mtd/nand/raw/lpc32xx_slc.c
+++ b/drivers/mtd/nand/raw/lpc32xx_slc.c
@@ -831,11 +831,11 @@ static int lpc32xx_nand_probe(struct platform_device *pdev)
 	if (IS_ERR(host->clk)) {
 		dev_err(&pdev->dev, "Clock failure\n");
 		res = -ENOENT;
-		goto err_exit1;
+		goto enable_wp;
 	}
 	res = clk_prepare_enable(host->clk);
 	if (res)
-		goto err_exit1;
+		goto enable_wp;
 
 	/* Set NAND IO addresses and command/ready functions */
 	chip->IO_ADDR_R = SLC_DATA(host->io_base);
@@ -874,19 +874,19 @@ static int lpc32xx_nand_probe(struct platform_device *pdev)
 				      GFP_KERNEL);
 	if (host->data_buf == NULL) {
 		res = -ENOMEM;
-		goto err_exit2;
+		goto unprepare_clk;
 	}
 
 	res = lpc32xx_nand_dma_setup(host);
 	if (res) {
 		res = -EIO;
-		goto err_exit2;
+		goto unprepare_clk;
 	}
 
 	/* Find NAND device */
 	res = nand_scan_ident(mtd, 1, NULL);
 	if (res)
-		goto err_exit3;
+		goto release_dma;
 
 	/* OOB and ECC CPU and DMA work areas */
 	host->ecc_buf = (uint32_t *)(host->data_buf + LPC32XX_DMA_DATA_SIZE);
@@ -920,21 +920,23 @@ static int lpc32xx_nand_probe(struct platform_device *pdev)
 	 */
 	res = nand_scan_tail(mtd);
 	if (res)
-		goto err_exit3;
+		goto release_dma;
 
 	mtd->name = "nxp_lpc3220_slc";
 	res = mtd_device_register(mtd, host->ncfg->parts,
 				  host->ncfg->num_parts);
-	if (!res)
-		return res;
+	if (res)
+		goto cleanup_nand;
 
-	nand_release(mtd);
+	return 0;
 
-err_exit3:
+cleanup_nand:
+	nand_cleanup(chip);
+release_dma:
 	dma_release_channel(host->dma_chan);
-err_exit2:
+unprepare_clk:
 	clk_disable_unprepare(host->clk);
-err_exit1:
+enable_wp:
 	lpc32xx_wp_enable(host);
 
 	return res;