x86: Remove CONFIG_X86_OOSTORE

This was an optimization that made memcpy type benchmarks a little
faster on ancient (Circa 1998) IDT Winchip CPUs.  In real-life
workloads, it wasn't even noticable, and I doubt anyone is running
benchmarks on 16 year old silicon any more.

Given this code has likely seen very little use over the last decade,
let's just remove it.

Signed-off-by: Dave Jones <davej@fedoraproject.org>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>

1 files changed, 0 insertions, 272 deletions

diff --git a/arch/x86/kernel/cpu/centaur.c b/arch/x86/kernel/cpu/centaur.c
index 8779edab684e..d8fba5c15fbd 100644
--- a/arch/x86/kernel/cpu/centaur.c
+++ b/arch/x86/kernel/cpu/centaur.c
@@ -8,236 +8,6 @@
 
 #include "cpu.h"
 
-#ifdef CONFIG_X86_OOSTORE
-
-static u32 power2(u32 x)
-{
-	u32 s = 1;
-
-	while (s <= x)
-		s <<= 1;
-
-	return s >>= 1;
-}
-
-
-/*
- * Set up an actual MCR
- */
-static void centaur_mcr_insert(int reg, u32 base, u32 size, int key)
-{
-	u32 lo, hi;
-
-	hi = base & ~0xFFF;
-	lo = ~(size-1);		/* Size is a power of 2 so this makes a mask */
-	lo &= ~0xFFF;		/* Remove the ctrl value bits */
-	lo |= key;		/* Attribute we wish to set */
-	wrmsr(reg+MSR_IDT_MCR0, lo, hi);
-	mtrr_centaur_report_mcr(reg, lo, hi);	/* Tell the mtrr driver */
-}
-
-/*
- * Figure what we can cover with MCR's
- *
- * Shortcut: We know you can't put 4Gig of RAM on a winchip
- */
-static u32 ramtop(void)
-{
-	u32 clip = 0xFFFFFFFFUL;
-	u32 top = 0;
-	int i;
-
-	for (i = 0; i < e820.nr_map; i++) {
-		unsigned long start, end;
-
-		if (e820.map[i].addr > 0xFFFFFFFFUL)
-			continue;
-		/*
-		 * Don't MCR over reserved space. Ignore the ISA hole
-		 * we frob around that catastrophe already
-		 */
-		if (e820.map[i].type == E820_RESERVED) {
-			if (e820.map[i].addr >= 0x100000UL &&
-			    e820.map[i].addr < clip)
-				clip = e820.map[i].addr;
-			continue;
-		}
-		start = e820.map[i].addr;
-		end = e820.map[i].addr + e820.map[i].size;
-		if (start >= end)
-			continue;
-		if (end > top)
-			top = end;
-	}
-	/*
-	 * Everything below 'top' should be RAM except for the ISA hole.
-	 * Because of the limited MCR's we want to map NV/ACPI into our
-	 * MCR range for gunk in RAM
-	 *
-	 * Clip might cause us to MCR insufficient RAM but that is an
-	 * acceptable failure mode and should only bite obscure boxes with
-	 * a VESA hole at 15Mb
-	 *
-	 * The second case Clip sometimes kicks in is when the EBDA is marked
-	 * as reserved. Again we fail safe with reasonable results
-	 */
-	if (top > clip)
-		top = clip;
-
-	return top;
-}
-
-/*
- * Compute a set of MCR's to give maximum coverage
- */
-static int centaur_mcr_compute(int nr, int key)
-{
-	u32 mem = ramtop();
-	u32 root = power2(mem);
-	u32 base = root;
-	u32 top = root;
-	u32 floor = 0;
-	int ct = 0;
-
-	while (ct < nr) {
-		u32 fspace = 0;
-		u32 high;
-		u32 low;
-
-		/*
-		 * Find the largest block we will fill going upwards
-		 */
-		high = power2(mem-top);
-
-		/*
-		 * Find the largest block we will fill going downwards
-		 */
-		low = base/2;
-
-		/*
-		 * Don't fill below 1Mb going downwards as there
-		 * is an ISA hole in the way.
-		 */
-		if (base <= 1024*1024)
-			low = 0;
-
-		/*
-		 * See how much space we could cover by filling below
-		 * the ISA hole
-		 */
-
-		if (floor == 0)
-			fspace = 512*1024;
-		else if (floor == 512*1024)
-			fspace = 128*1024;
-
-		/* And forget ROM space */
-
-		/*
-		 * Now install the largest coverage we get
-		 */
-		if (fspace > high && fspace > low) {
-			centaur_mcr_insert(ct, floor, fspace, key);
-			floor += fspace;
-		} else if (high > low) {
-			centaur_mcr_insert(ct, top, high, key);
-			top += high;
-		} else if (low > 0) {
-			base -= low;
-			centaur_mcr_insert(ct, base, low, key);
-		} else
-			break;
-		ct++;
-	}
-	/*
-	 * We loaded ct values. We now need to set the mask. The caller
-	 * must do this bit.
-	 */
-	return ct;
-}
-
-static void centaur_create_optimal_mcr(void)
-{
-	int used;
-	int i;
-
-	/*
-	 * Allocate up to 6 mcrs to mark as much of ram as possible
-	 * as write combining and weak write ordered.
-	 *
-	 * To experiment with: Linux never uses stack operations for
-	 * mmio spaces so we could globally enable stack operation wc
-	 *
-	 * Load the registers with type 31 - full write combining, all
-	 * writes weakly ordered.
-	 */
-	used = centaur_mcr_compute(6, 31);
-
-	/*
-	 * Wipe unused MCRs
-	 */
-	for (i = used; i < 8; i++)
-		wrmsr(MSR_IDT_MCR0+i, 0, 0);
-}
-
-static void winchip2_create_optimal_mcr(void)
-{
-	u32 lo, hi;
-	int used;
-	int i;
-
-	/*
-	 * Allocate up to 6 mcrs to mark as much of ram as possible
-	 * as write combining, weak store ordered.
-	 *
-	 * Load the registers with type 25
-	 *	8	-	weak write ordering
-	 *	16	-	weak read ordering
-	 *	1	-	write combining
-	 */
-	used = centaur_mcr_compute(6, 25);
-
-	/*
-	 * Mark the registers we are using.
-	 */
-	rdmsr(MSR_IDT_MCR_CTRL, lo, hi);
-	for (i = 0; i < used; i++)
-		lo |= 1<<(9+i);
-	wrmsr(MSR_IDT_MCR_CTRL, lo, hi);
-
-	/*
-	 * Wipe unused MCRs
-	 */
-
-	for (i = used; i < 8; i++)
-		wrmsr(MSR_IDT_MCR0+i, 0, 0);
-}
-
-/*
- * Handle the MCR key on the Winchip 2.
- */
-static void winchip2_unprotect_mcr(void)
-{
-	u32 lo, hi;
-	u32 key;
-
-	rdmsr(MSR_IDT_MCR_CTRL, lo, hi);
-	lo &= ~0x1C0;	/* blank bits 8-6 */
-	key = (lo>>17) & 7;
-	lo |= key<<6;	/* replace with unlock key */
-	wrmsr(MSR_IDT_MCR_CTRL, lo, hi);
-}
-
-static void winchip2_protect_mcr(void)
-{
-	u32 lo, hi;
-
-	rdmsr(MSR_IDT_MCR_CTRL, lo, hi);
-	lo &= ~0x1C0;	/* blank bits 8-6 */
-	wrmsr(MSR_IDT_MCR_CTRL, lo, hi);
-}
-#endif /* CONFIG_X86_OOSTORE */
-
 #define ACE_PRESENT	(1 << 6)
 #define ACE_ENABLED	(1 << 7)
 #define ACE_FCR		(1 << 28)	/* MSR_VIA_FCR */
@@ -362,20 +132,6 @@ static void init_centaur(struct cpuinfo_x86 *c)
 			fcr_clr = DPDC;
 			printk(KERN_NOTICE "Disabling bugged TSC.\n");
 			clear_cpu_cap(c, X86_FEATURE_TSC);
-#ifdef CONFIG_X86_OOSTORE
-			centaur_create_optimal_mcr();
-			/*
-			 * Enable:
-			 *	write combining on non-stack, non-string
-			 *	write combining on string, all types
-			 *	weak write ordering
-			 *
-			 * The C6 original lacks weak read order
-			 *
-			 * Note 0x120 is write only on Winchip 1
-			 */
-			wrmsr(MSR_IDT_MCR_CTRL, 0x01F0001F, 0);
-#endif
 			break;
 		case 8:
 			switch (c->x86_mask) {
@@ -392,40 +148,12 @@ static void init_centaur(struct cpuinfo_x86 *c)
 			fcr_set = ECX8|DSMC|DTLOCK|EMMX|EBRPRED|ERETSTK|
 				  E2MMX|EAMD3D;
 			fcr_clr = DPDC;
-#ifdef CONFIG_X86_OOSTORE
-			winchip2_unprotect_mcr();
-			winchip2_create_optimal_mcr();
-			rdmsr(MSR_IDT_MCR_CTRL, lo, hi);
-			/*
-			 * Enable:
-			 *	write combining on non-stack, non-string
-			 *	write combining on string, all types
-			 *	weak write ordering
-			 */
-			lo |= 31;
-			wrmsr(MSR_IDT_MCR_CTRL, lo, hi);
-			winchip2_protect_mcr();
-#endif
 			break;
 		case 9:
 			name = "3";
 			fcr_set = ECX8|DSMC|DTLOCK|EMMX|EBRPRED|ERETSTK|
 				  E2MMX|EAMD3D;
 			fcr_clr = DPDC;
-#ifdef CONFIG_X86_OOSTORE
-			winchip2_unprotect_mcr();
-			winchip2_create_optimal_mcr();
-			rdmsr(MSR_IDT_MCR_CTRL, lo, hi);
-			/*
-			 * Enable:
-			 *	write combining on non-stack, non-string
-			 *	write combining on string, all types
-			 *	weak write ordering
-			 */
-			lo |= 31;
-			wrmsr(MSR_IDT_MCR_CTRL, lo, hi);
-			winchip2_protect_mcr();
-#endif
 			break;
 		default:
 			name = "??";