BMC/Intel-BMC/linux.git/drivers/rtc/rtc-omap.c, branch dev-4.17

rtc: omap: stop validating rtc_time in .set_time and .set_alarm

2018-03-02T09:12:21+00:00

The RTC core is always validating the rtc_time struct before calling .set_time or .set_alarm. It is not necessary to do it again. Also, rtc_time_to_tm never generates an invalid rtc_tm (it can be out of range though). Signed-off-by: Alexandre Belloni

rtc: omap: call rtc_nvmem_register()

2018-03-01T09:49:20+00:00

Call rtc_nvmem_register instead of letting the core do it and stop using the nvmem_config member of struct rtc_device. Signed-off-by: Alexandre Belloni

rtc: omap: fix unbalanced clk_prepare_enable/clk_disable_unprepare

2017-12-18T22:05:11+00:00

There are 2 error paths after clk_prepare_enable() was called, where clk_disable_unprepare() is missing. Found by Linux Driver Verification project (linuxtesting.org). Signed-off-by: Andreas Platschek Signed-off-by: Alexandre Belloni

rtc: omap: Support scratch registers

2017-11-08T06:52:15+00:00

Register an nvmem device to expose the 3 scratch registers (total of 12 bytes) to both userspace and kernel space. Reviewed-by: Sekhar Nori Tested-by: Keerthy Reviewed-by: Keerthy Signed-off-by: Alexandre Belloni

rtc: omap: switch to rtc_register_device

2017-10-31T16:31:13+00:00

This removes a possible race condition and crash and allows for further improvement of the driver. Signed-off-by: Alexandre Belloni

rtc: omap: fix error path when pinctrl_register fails

2017-10-31T16:31:10+00:00

If pinctrl_register() fails probe will return with an error without locking the RTC and disabling pm_runtime. Set ret and jump to err instead. Fixes: 97ea1906b3c2 ("rtc: omap: Support ext_wakeup configuration") Signed-off-by: Alexandre Belloni

rtc: omap: mark PM methods as __maybe_unused

2017-03-09T00:32:32+00:00

Instead of using #ifdef guards around PM methods, let's annotate them as __maybe_unused, as it provides better compile coverage. Also drop empty stub for omap_rtc_runtime_resume(). Signed-off-by: Dmitry Torokhov Signed-off-by: Alexandre Belloni

rtc: omap: remove incorrect __exit markups

2017-03-09T00:32:31+00:00

Even if bus is not hot-pluggable, devices can be unbound from the driver via sysfs, so we should not be using __exit annotations on remove() methods. The only exception is drivers registered with platform_driver_probe(), which specifically disables sysfs bind/unbind attributes. Signed-off-by: Dmitry Torokhov Reviewed-By: Sebastian Reichel Signed-off-by: Alexandre Belloni

pinctrl: Widen the generic pinconf argument from 16 to 24 bits

2017-01-26T14:22:32+00:00

The current pinconf packed format allows only 16-bit argument limiting the maximum value 65535. For most types this is enough. However, debounce time can be in range of hundreths of milliseconds in case of mechanical switches so we cannot represent the worst case using the current format. In order to support larger values change the packed format so that the lower 8 bits are used as type which leaves 24 bits for the argument. This allows representing values up to 16777215 and debounce times up to 16 seconds. We also convert the existing users to use 32-bit integer when extracting argument from the packed configuration value. Signed-off-by: Mika Westerberg Reviewed-by: Andy Shevchenko Signed-off-by: Linus Walleij

rtc: omap: prevent disabling of clock/module during suspend

2016-11-04T22:11:39+00:00

If RTC is running from an internal clock source, the RTC module can't be disabled; otherwise it stops ticking completely. Current suspend handler implementation disables the clock/module unconditionally, instead fix this by disabling the clock only if we are running on external clock source, which is not affected by suspend. The prevention of disabling the clock must be done via implementing the runtime_pm handlers for the device, and returning an error code from the runtime suspend handler; otherwise OMAP core PM will disable the clocks for the driver. Signed-off-by: Tero Kristo Signed-off-by: Keerthy Signed-off-by: Alexandre Belloni