BMC/Intel-BMC/linux.git/drivers/bluetooth/hci_intel.c, branch dev-4.3

Bluetooth: hci_intel: Add support for platform driver

2015-08-28T19:00:38+00:00

A platform device can be used to provide some specific resources in order to manage the controller. In this first patch we retrieve the reset gpio which is used to power on/off the controller. The main issue is to match the current tty with the correct pdev. In case of ACPI, we can easily find the right tty/pdev pair because they are both child of the same UART port. If controller is powered-on from the driver, we need to wait for a HCI boot event before being able to send any command. Signed-off-by: Loic Poulain Signed-off-by: Marcel Holtmann

Bluetooth: hci_intel: Add Intel baudrate configuration support

2015-08-28T19:00:37+00:00

Implement the set_baudrate callback for hci_intel. - Controller requires a read Intel version command before updating its baudrate. - The operation consists in an async cmd since the controller does not respond at the same speed. - Wait 100ms to let the controller change its baudrate. - Clear RTS until we change our own UART speed Manage speed change in the setup function, we need to restore the oper speed once chip has booted on patched firmware. Signed-off-by: Loic Poulain Signed-off-by: Marcel Holtmann

Bluetooth: btintel: Create common function for Intel version info

2015-07-23T15:10:50+00:00

The Intel version information is shared between USB and UART drivers and with that move it into a generic function of the Intel module. Signed-off-by: Marcel Holtmann Signed-off-by: Johan Hedberg

Bluetooth: btintel: Create common Intel Secure Send function

2015-07-23T15:10:50+00:00

The Intel Secure Send command is used the same in USB and UART drivers and with that move a generic version into the Intel module. Signed-off-by: Marcel Holtmann Signed-off-by: Johan Hedberg

Bluetooth: hci_uart: Add Intel address configuration support

2015-07-23T15:10:50+00:00

The Intel specific Bluetooth module provides support for pubic address configuration. So make sure that it is enabled for Intel UART devices. Signed-off-by: Marcel Holtmann Signed-off-by: Johan Hedberg

Bluetooth: hci_uart: Add basic support for Intel Lightning Peak devices

2015-07-23T15:10:49+00:00

The Intel Lightning Peak devices do not come with Bluetooth firmware loaded and thus require a full download of the operational Bluetooth firmware when the device is attached via the Bluetooth line discipline. Lightning Peak devices start with a bootloader mode that only accepts a very limited set of HCI commands. The supported commands are enough to identify the hardware and select the right firmware to load. Signed-off-by: Loic Poulain Signed-off-by: Marcel Holtmann

Bluetooth: hci_uart: Use generic Intel support for address setting

2015-04-07T16:48:21+00:00

The Bluetooth address setting for Intel devices is provided by a generic module now. Start using that module instead of relying it being included in the driver. Signed-off-by: Marcel Holtmann Signed-off-by: Johan Hedberg

Bluetooth: hci_uart: Add support Intel address configuration

2015-04-07T16:47:08+00:00

When using vendor detection, this adds support for the Intel specific address configuration command. Signed-off-by: Marcel Holtmann Signed-off-by: Johan Hedberg