BMC/Intel-BMC/linux.git/arch/sh/drivers/pci/Makefile, branch dev

sh: pci: Support slot 4 routing on SDK7786.

2010-10-13T22:37:01+00:00

SDK7786 supports connecting either slot3 or 4 to the same PCIe port by way of FPGA muxing. By default the vertical slot 3 on the baseboard is enabled, so this adds in a command line option for forcibly enabling the slot 4 edge connector. If nothing has been specified on the command line, we fall back to reading the resistor values for card presence to figure out where to route the port to. Signed-off-by: Paul Mundt

sh: Enable PCI66 support for SH7780 host controller.

2010-02-01T04:01:42+00:00

This adds some helper glue for scanning the bus and determining if all of the devices are 66MHz capable or not before flipping on 66MHz mode. This isn't quite to spec, but it's fairly consistent with what other embedded controllers end up having to do. Scanning code cribbed from the MIPS txx9 PCI code. Signed-off-by: Paul Mundt

sh: Generalize SH7786 PCIe support.

2010-01-15T10:13:56+00:00

Previously this was only built in for Urquell boards, but the same approach can be used on SDK7786 now that the mode pin reading is supported, so make it generic to SH7786. Signed-off-by: Paul Mundt

sh: pci: Initial PCI-Express support for SH7786 Urquell board.

2009-06-17T09:20:48+00:00

This adds initial support for the PCI-Express module in the SH7786, particularly as it relates to the urquell platform. Presently it is only supported in root complex mode, with endpoint mode still requiring more debugging. 29/32-bit mode and lane configurations are selectable via board mode pins, and are otherwise fixed. Only 4x and 1x PCI channels are presently handled, the PCI bridge still requires additional debugging and stabilization in hardware. Signed-off-by: Paul Mundt

sh: pci: SH7786 PCI ops.

2009-06-15T21:26:08+00:00

This adds in preliminary support for the SH7786 PCIe module PCI ops, and the corresponding module definitions. Signed-off-by: Paul Mundt

sh: pci: Rename pci-new.c to pci.c.

2009-04-20T12:53:33+00:00

pci-new.c is now in a state to replace the old pci.c, rename it accordingly. Signed-off-by: Paul Mundt

sh: pci: Roll pci-lib in to pci-new.

2009-04-20T12:51:19+00:00

Now that the pci-auto cruft is gone, pci-lib can go away. Roll it back in to pci-new.c where it originally split off from. Signed-off-by: Paul Mundt

sh: pci: Kill off the last remnants of the now unused pci-auto code.

2009-04-20T12:46:42+00:00

Signed-off-by: Paul Mundt

sh: pci: Move the se7751 fixups in to arch/sh/drivers/pci/.

2009-04-20T12:42:59+00:00

The se7751 was still doing the PCI fixups in its own board directory, so we move it over to arch/sh/drivers/pci/ with the rest of the board fixups. It has bitrotted significantly over the years, so will still likely need a bit of work to bring back up to date. Signed-off-by: Paul Mundt

sh: pci: Consolidate lboxre2 and r2d IRQ fixups.

2009-04-20T12:27:15+00:00

Signed-off-by: Paul Mundt